The end of summer is a good time to cut the most grown species and multiply them for the next season. Usually this process takes quite a long time, but fortunately we can speed up it. All you have to do is prepare a homemade conditioner that will stimulate the plant to release new roots. We suggest how to do it.
Plants can be reproduced in different ways. However, many people focus on rooting seedlings. This is a relatively easy method. However, it is worth knowing how to perform it step by step so that the process is successful:
- Downloading seedlings – We choose a strong rush of plants, cut it off with a sharp and clean tool. The cut momentum should have about 2-3 leaves, and the cut is best done just below the knot. Let’s also remember to remove the lower leaves so that they do not rot.
- Preparation of the substrate – Choose the right soil for rooting. A mixture of peat and sand in a 1: 1 ratio is usually recommended. We can also use ready substrates available in garden stores.
- Planting – We put in the ground, remembering that they are covered with ground.
After planting, let’s make sure that The ground was constantly moist, but not soaked. Let’s also provide seedlings with the right temperature and humidity.
Read also:
Due to the fact that some plant species produce roots for quite a long time and need a large amount of energy for this, it is to support them in this process. We can do this by preparing our own valuable solution, thanks to which the seedlings will root faster, In addition, they will be strengthened.
It turns out that we will make such a valuable preparation, reaching for the kitchen after. It has a positive effect not only on people, but also on plants. Provides enzymes, vitamin C, B vitamins and sugars that nourish tissues after cutting shoots. In addition, honey has antifungal and antibacterial effects, so it will protect our plants.
It is enough We melt one teaspoon of natural honey in 1.5 liters of lukewarm water. Mix the whole thoroughly and put the tip of our seedling in this solution. Soak the plant in this way for about 12 hours, and then put it in a damp ground. After a few days, the first roots will appear. However, be careful not to use too much water and use it only to soak the ends of the cuttings.
