Phone won’t charge, even if you use the original cable? The culprit may be dust, small dirt or moisture in the connector. We’ll show you how to clean it safely by hand, without the risk of damage and with the certainty that the device will run reliably again.
The charging connector is a small hole that most of us don’t pay much attention to until it starts to get annoying. At the same time, it is in it that dust from pockets, small fibers or grease settles daily, which prevent the correct . However, when the phone stops responding to the cable connection, there is no need to immediately panic or run to the service center. just know how to clean the connector the right way: carefully, dry and without metal tools.
Cleaning the charging port of your mobile phone is easier than it seems. But always proceed correctly and avoid procedures that could damage your phone:
What causes problems and what to clean
The most common cause of bad charging is the deposit of small dirt that gets into the port by carrying the phone in your pocket or purse. Dust accumulates and is pushed deeper in when the connector is inserted, preventing contact. If moisture also remains in the port, corrosion may also occur.
Use only for cleaning safe tools such as a wooden or plastic toothpick, a cotton swab and a can of compressed air. Under no circumstances should metal objects such as staples, needles or pins be used, which can cause a short circuit and permanently damage the connector. Also avoid blowing through your mouth as there is moisture in your breath that can enter the device.
Start by turning off your phone. Direct compressed air into the opening in several short bursts to blow out loose particles. If anything remains inside, take a toothpick wrapped with a piece of cotton wool or a cotton bud and very gently remove the remaining dirt. Work slowly and under good light to prevent filaments from catching on the contacts.
How to remove stubborn dirt or moisture
However, sometimes even air and a stick are not enough. In this case, the minimum amount can be used alcohol. All you need is a few drops on the tip of a cotton swab. The alcohol evaporates quickly and helps to dissolve grease or dirt residues. After cleaning, leave the phone alone for at least half an hour to allow the port to dry completely.
If you suspect that water has gotten inside, never dry the phone with a hair dryer or plug it into the . Just turn it off, wipe it with a dry cloth and let it dry freely with the connector facing down. Only after a few hours, test whether the charging works again.
A good preventative measure is to use small silicone plugs into the charging portwhich prevents dust and sand from entering. They are especially suitable for those who often carry the phone outdoors or work in a dusty environment.
Always proceed with caution
Proper cleaning of the charging connector requires no complicated tools, just a little patience and gentleness. Avoid water, metal objects and rough pressure: the only correct way is dry, gentle and careful cleaning. This is the only way to ensure that your smartphone will charge again without problems and that its connector will remain in perfect condition for many years.
