I take it from the kitchen and rub it on the tap. The stone disappears in just a moment

I take it from the kitchen and rub it on the tap. The stone disappears in just a moment

Hard water causes unsightly deposits to quickly appear on the fittings, which are difficult to remove. Worse still, over time it can not only look bad, but also affect the operation of the faucet. However, it turns out that there is a simple home trick that works quickly and does not require expensive products.

Hard water is a common problem, which also makes it difficult to clean some elements in the kitchen or bathroom. Due to the precipitation of compounds from water calcium and magnesium, a light, unsightly precipitate is formed.

Not only does it not look good, but it also reduces the effectiveness of cleaning products and may also result in the failure of the fittings. So it’s worth knowing how get rid of this problem at homewhich may be even more effective than store-bought products.

Read also:

It turns out that we need something that we usually keep in our kitchen, more specifically a lemon. Due to the fact that it has an acidic formula, it will deal with stone perfectly. All we need to do is take one fruit and cut it into slices. Then we stuff each of them onto the tap and move it to the very bottom, i.e. where the stone most often accumulates.

Leave the slices like this for about half an hour to give the lemon juice a chance to work. Then we remove them, rinse the tap with warm water and it’s ready. Thanks to this simple method, we will dissolve the scale in just a few moments and restore it to our bathroom or kitchen.

However, this is not the only solution for a stone-covered tap. If you don’t have lemon at hand, you can use vinegar. Just soak a paper towel in it and apply it to problem areas. Leave it on for about 30 minutes and then remove the towel. This will dissolve the stone and the surface will become shiny again.

Another proven way to reduce build-up is to regularly clean your taps with baking soda. Just mix it with a small amount of water to create a thick paste. Apply it to the damp surface of the fittings and spread it gently with a soft cloth.

Due to the fact that soda has a slightly abrasive effect, it will remove sediment without the risk of scratching the metal. After a few minutes, rinse everything with water and polish the tap dry. This treatment not only improves the appearance, but also slows down the re-deposition of scale.

source

News Room USA | LNG in Northern BC