The biggest advantage of this method is that it uses products present in almost every home. A half lemon is enough spread with a small amount of toothpasteand then put it in a pouch for underwear to prevent the fruit from falling apart during washing. A portion of baking soda (about 100-150 g) is poured into the drum, and the same amount is added to the detergent drawer. The whole starts in an empty cycle at a high temperature, preferably 90 ° C, which allows the ingredients to work properly. Remember to leave the door and drawer open after cleaning the door, for the device to dry well.
The secret to the effectiveness of lemon and toothpaste lies in the combination of several chemical properties. Citric acid from the fruit dissolves the stone and the remains of powders, toothpaste thanks to the presence of small abrasions and detergents helps to remove biofilm and deposits, and baking soda neutralizes unpleasant odors and stabilizes the reaction. The high temperature additionally supports the operation of these ingredients – kills, softens the hardened residues of detergents and facilitates their rinsing. Thanks to this, the washing machine after such cleaning It not only smells fresh, but also works more efficiently.
Read also:
Regular use of this method is important not only for the drum hygiene, but also for device life. Removing the stone from the heater reduces energy consumption, the clean gasket reduces the development of mold, and the fresh interior of the drum prevents the transfer of an unpleasant smell to clothes. However, a few rules must be remembered: lemon should always be placed in a bag so that its pieces do not reach the drain, and the home agent must not be combined with chlorine -based bleach. In this way a simple method allows you to take care of the washing machine without the risk of damage to its elements.
The washing machine’s cleaning frequency should be adapted to home conditions and intensity of use. On farms with hard water and frequent laundry, it is recommended to run an empty cycle at 60-90 ° C every 3-4 weeks. If the device works less often, it is enough to repeat such a procedure every 6-8 weeks. In addition, it is worth introducing a routine of other activities: a drawer for detergents and a rubber gasket is good to wipe every 1-2 weeks, and check the drain pump filter every 2-3 months. Appropriate dosing of powder or fluid is also of key importance, because the excess of detergents promotes the formation of sticky deposits.
Read also:
The best results are done by cleaning step by step and using simple solutions. The drawer should be removed and soaked in warm water with the addition of citric acid, leaving it in a solution for about half an hour, and then scrub with a brush. The gasket can be washed with a paste prepared from and a small amount of water, remembering to dry thoroughly after finishing work. Before turning the empty cycle at a high temperature, it is also good to clean the filter and see if the leftovers are in the outflow. After each cleaning of the door and the drawer, you need to be lifted, that moisture evaporates and does not create an environment that favors mold.
Regular maintenance quickly brings visible results. A musty smell disappears from the laundry, the door glass is not covered with a greasy sediment, and the interior of the device remains fresh for a long time. The stone -free heater makes the water heats up faster, which reduces energy consumption and stabilizes the washing machine. The clean filter eliminates the risk of locking in the outflow and reduces the sounds made by the pump. As a result, the device works more efficiently, and the risk of more serious failures requiring service clearly decreases.
