When water starts to accumulate on the shower floor and takes longer than usual to drain, it is a sign that the drain may be partially blocked. The accumulation of hair, hygiene product residue and other particles ends up making it difficult for water to pass through, creating a problem that, although common, can become quite uncomfortable in everyday life.
According to Notícias ao Minuto, there is a simple solution that can help solve the problem in a short time and without resorting to more aggressive products. The method uses ingredients that many people already have at home and takes about half an hour from the start of the process to the final result.
A simple solution to a common problem
To put this trick into practice, you only need four ingredients: a cup of salt, a cup of baking soda, a cup of vinegar and hot water.
The first step is to mix the salt and baking soda in a bowl. Once well wrapped, the two ingredients must be placed directly into the shower drain.
Then, add the vinegar gradually. When the ingredients come into contact, it is normal for a visible reaction to occur, with the formation of small bubbles. This is an expected process and is part of how the mixture works.
After this step, the solution must remain in the drain for between 15 and 30 minutes. The waiting time allows the mixture to act on the accumulated residues, helping to free the passage of water.
Finally, just pour hot water down the drain. This step helps to remove residues that were released during the process and improve drainage.
In addition to helping to unclog the drain, this combination can also help reduce unpleasant odors that sometimes appear in the plumbing. Remains of soap, shower gel, shampoo and other substances used daily tend to accumulate and encourage the appearance of bad smells.
Another advantage cited for this mixture is the ability to help eliminate small accumulations of fat and limescale that form over time. Even so, it is important to be careful when using hot water to avoid burns.
The toilet area that almost no one cleans
There is another area of the bathroom that often goes unnoticed during regular cleanings. Although the inside of the toilet and its seat usually receive attention, the base of the toilet is often forgotten.
This is the area where the toilet is fixed to the floor, a place where moisture, dust and various types of dirt can accumulate over time. Because it is less visible, it often does not receive the same attention as other surfaces in the bathroom.
Cleaning this area can be done with the products commonly used to sanitize the toilet or floor. After applying the chosen solution, simply let it act for a few minutes and clean the entire surface carefully. A brush can help reach difficult corners.
According to the same source, another alternative is to use a mixture of baking soda and white vinegar. This solution can be applied both inside the toilet bowl and on its base, helping to remove accumulated residue and keep the area cleaner.
Also read:
