Do you spend an hour or two on the floor, and after drying the panels are full streaks? The reason may be the wrong selection of cleaning agents or moping errors. As it turns out, you don’t need strong chemistry to wash the floor. Just a few drops of vascular fluid. In this way you will avoid streaks on the floor.
You buy glossy floor panels with a deep color, and sometimes they become bure, matte and bland. What is the problem? Incorrect washing and care contribute to this.
The use of strong cleaning agents can effectively destroy the top layer of panels that is responsible for their splendor. Some agents, such as cleaning milk, contains microdrobines, which remove difficult dirt, but at the same time act like very fine sandpaper. They draw panels and dull them. Always use cleaning agents to clean the floor.
Also read:
The floor can be scratched by unsecured furniture, but also sharp cloths, sponges or brushes used to wash them. It is worth paying attention to the material from which the MOP is made, as well as its purity. They may be in it sand particles that will also work like sandpaper.
Incorrect washing of floor panels, including leaving it wet or too much foam in the bucket to the creation of streaks. They also cause the panels to lose their glow.
Instead of strong cleaning agents Add just a few drops to the bucket with warm water . In this way, you will effectively degrease the floor, remove the stains and prevent foam in the bucket. The water for cleaning the floor will allow you to allow you restore the glow of your panels. To make washing the floor effective, it is worth sticking to these few rules:
- Before washing, vacuum the floor and remove all particles from it that can outline it during mopping;
- Prepare water for cleaning the floor;
- Use a microfiber mop. This material is soft and perfectly removes dirt;
- Finally, dry the floor with a dry mop.
Read also:
Although drying the floor will extend the time spent at the mop, it will allow you to avoid a matte floor. In this way, contrary to appearances, you save time that would require brushing the floor full of spots and streaks.
Floor panels should be vacuumed and washed regularly. Any accumulation of dirt can cause scratching panels when walking or moving furniture. The furniture alone, especially the moving ones – secure with felt.
In floor care, it is also important shrinage. It is thanks to this treatment that your panels will look like new. You can use panel paste, shine liquid or Home remedy made of vinegar and oil.
For dulling of the floor The quality of the panels is influenced. When buying them, it is worth paying attention to the abrasion class. The higher it is, the more resistant to scratches. It is worth choosing panels for home use in the AC4 and higher class.
